Muhammad Rizal, Jaharah A. Ghani, Mohd Zaki Nuawi, Che Hassan Che Haron
Cutting force is an important signal in machining process and has been widely used for tool condition monitoring. Monitoring the condition of the cutting tool in the machining process is very important to maintain the machined surface quality and consequently reduce inspection costs and increase productivity. This paper utilizes I-kaz-based analysis of cutting force signal to monitor the status of tool wear. The cutting force signals are measured by two channels of strain gauge that were mounted on the surface of tool holder. Experiments were carried out by turning hardened carbon steel and cutting force signals were analyzed using I-kaz™ technique by integrating two component of signals (I-kaz 2D, Z2∞), I-kaz of cutting force (Z∞ of Fy), and I-kaz of feed force (Z∞ of Fx). The results show that I-kaz of feed force can be effectively used to monitor tool wear progression during turning operation. © (2014) Trans Tech Publications, Switzerland.
Department of Mechanical and Materials Engineering, Universiti Kebangsaan Malaysia, 43600, Bangi, Malaysia; Department of Mechanical Engineering, Syiah Kuala University (UNSYIAH), 23111, Darussalam Banda Aceh, Indonesia; Centre for Automotive Research, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor, Malaysia
Research at a Glance
Register to unlock
Topics & SDG Alignment
Register to unlock
Collaboration
Register to unlock
Author Profile (Selected)
Register to unlock
References Overview
Register to unlock
Journal & Source
Register to unlock
Metadata & Integrity
Register to unlock