Teuku Firsa, M. Tadjuddin, A. Udink, Iskandar Hasanuddin
Micromachining technology is a challenge in industrial production to meet the demand for components for machinery. In this research, a study of the best parameters was required to produce the best hole accuracy and the lowest burr formation in the inlet and exit holes using microdrilling. The work-piece material and cutting tool used respectively was a brass plate with a thickness of 0.5 mm and a micro drill with a diameter of 0.2 mm commonly used for electronic PCBs. The quality of holes was measured and observed by using a stereomicroscope (optical equipment). This microscope can zoom up to 50x objects to facilitate measurement. The microscope was attached by using a digital camera type YW-200 so that the object of observation could be measured using a computer. The result shows that the largest deviation of hole diameter (0.217 mm) occurred at a spindle speed of 14,000 rpm with the lowest feed rate (5 mm/min). Meanwhile, the smallest deviation of hole diameter (0.202 mm) occurred at a spindle speed of 20,000 rpm with a maximum feed rate of 10 mm/min. The maximum burr height (0.050 mm) occurred at a spindle speed of 17,000 rpm and a feed rate of 10 mm/min. In addition, the minimum burr height (0.038 mm) occurred at a spindle speed of 14,000 rpm and a feed rate of 5 mm/min. Therefore, it can be concluded that the deviation of hole diameter was inversely proportional to the spindle speed, and the height of the burr formation was directly proportional to the feed rate. © 2020 Trans Tech Publications Ltd, Switzerland.
Department of Mechanical and Industrial Engineering, Syiah Kuala University, Indonesia
Research at a Glance
Register to unlock
Topics & SDG Alignment
Register to unlock
Collaboration
Register to unlock
Author Profile (Selected)
Register to unlock
References Overview
Register to unlock
Journal & Source
Register to unlock
Metadata & Integrity
Register to unlock