Experimental studies on combustion characteristics of oil-palm biomass in fluidized-bed: A heat energy alternative

Open

M. Reza Hani, Mahidin, Husni Husin, Khairil, Hamdani, Erdiwansyah, Hisbullah, Muhammad Faisal, Mahyudin, Muhtadin, M.I. Afkar, O. Taka, Maizirwan Mel

2020 Journal of Advanced Research in Fluid Mechanics and Thermal Sciences Vol. 68 Issue 2 Article Cited by 16 SDG 7SDG 17 Quartile

Abstract

One of the technologies that can be used to meet energy needs is biomass combustion. In this study, the oil palm biomass fuels used were empty fruit bunches, oil palm fibers, oil palm midribs, and palm kernel shells. This research was carried out by a direct combustion method using a fluidized-bed combustor. The purpose of this experiment was to investigate the reaction of kinetics and the mechanism of combustion of oilpalm biomass in fluidized-bed combustor. The characteristics observed in this test were the combustion temperature profile, flue-gas composition, and the composition of the ash-deposit chemical compound. The results of the experiments conducted showed that the best biomass combustion temperature profile was recorded at 2 kg biomass with an air flow rate of 0.9375 m3/s at 90.1%. The maximum temperature of biomass combustion recorded at biomass 3 kg with an air flow rate of 1.25 m3/s are 950°C (95%). The higher conversion combustion of biomass was found at biomass condition of 3 kg with an air flow rate of 0.9375 m3/s. The value of O2 emissions from biomass combustion shows that it was very small 0.2%. While the highest CO2 value was recorded at 19.9%. The highest combustion efficiency on FBC found 1 kg of biomass fuel with an air flow rate of 0.0654 m3/s recorded 94.9%. © 2020 PENERBIT AKADEMIA BARU.

Affiliations

Doctoral Program in Engineering, Syiah Kuala University, Banda Aceh, 23111, Indonesia; Department of Chemical Engineering, Syiah Kuala University, Banda Aceh, 23111, Indonesia; Department of Mechanical Engineering, Syiah Kuala University, Banda Aceh, 23111, Indonesia; Department Faculty of Engineering, Universitas Serambi Mekkah, Banda Aceh, 23245, Indonesia; Department of Mechanical Engineering, Universitas Abulyatama Aceh, Aceh Besar, 23372, Indonesia; Department of Biotechnology Engineering, Kulliyah of Engineering, International Islamic University Malaysia, Gombak Kuala Lumpur, 53100, Malaysia; Research Center for Environmental and Natural Resources, Universitas Syiah Kuala, Banda Aceh, 23111, Indonesia

Research at a Glance

Premium content — register to unlock

Research at a Glance

Register to unlock

Topics & SDG Alignment

Premium content — register to unlock

Topics & SDG Alignment

Register to unlock

Collaboration

Premium content — register to unlock

Collaboration

Register to unlock

Author Profile (Selected)

Premium content — register to unlock

Author Profile (Selected)

Register to unlock

References Overview

Premium content — register to unlock

References Overview

Register to unlock

Journal & Source

Premium content — register to unlock

Journal & Source

Register to unlock

Metadata & Integrity

Premium content — register to unlock

Metadata & Integrity

Register to unlock