Shear Capacity Analysis of High-Strength Reinforced Concrete Beams using Geopolymer Flyash and Palm Oil Blast Furnace Slag as Additives and Aggregate Substitution

Open

T.B. Aulia, Muttaqin, M. Afifuddin, M. Zaki, S. Merriza

2018 IOP Conference Series: Materials Science and Engineering Vol. 434 Issue 1 Conference paper Cited by 13 SDG 12 Quartile

Abstract

High-strength concrete made with a lot of cement, aggregates and super plasticizer leading to expensive cost. On the contrary, manufacturing of cement is un-environmental friendly because it needs high fuel consumption and releases the CO2 emission to the atmosphere. Moreover, the availability of aggregates coming from river and natural rock decreases over time. This research aims to analyze shear capacity of high-strength reinforced concrete (HSRC) beams added with geopolymer flyash i.e., 15% coal flyash (CFA), 10% pozzolanic flyash (PFA) and 15% palm oil blast furnace slag ash (POSFA) from cement weight as additives; 10% palm oil blast furnace slag (POSS) and 20% pozzolanic sand (PSS) as fine aggregate substitution; and 40% palm oil blast furnace slag as coarse aggregate substitution (POSCA). One plain beam without flyash and aggregate substitution (PBHSC) was tested as comparison. Shear capacity of beams was tested by giving a concentrated load which divided then into two point load (third point loading). Result of shear test showed that all beams experienced shear failure as planned, obtained by applying the actual capacity ratio of flexure to shear 2.29. Aggregate substitution from palm oil blast furnace slag both as fine and coarse aggregates could enhance shear capacity of HSRC beam compared with plain beam. The hardness of palm oil blast furnace slag contributed to this increase, which has wearing value not much different than split, i.e., 4.7% compared with 6.7%. Utilization of flyash did not contribute to the increase of shear capacity as well, although its compressive strength enhanced when compared to PBHSC. © Published under licence by IOP Publishing Ltd.

Affiliations

University of Syiah Kuala, Banda Aceh, 23111, Indonesia; Balai Jasa Konstruksi Wilayah i, Banda Aceh, 23111, Indonesia

Research at a Glance

Premium content — register to unlock

Research at a Glance

Register to unlock

Topics & SDG Alignment

Premium content — register to unlock

Topics & SDG Alignment

Register to unlock

Collaboration

Premium content — register to unlock

Collaboration

Register to unlock

Author Profile (Selected)

Premium content — register to unlock

Author Profile (Selected)

Register to unlock

References Overview

Premium content — register to unlock

References Overview

Register to unlock

Journal & Source

Premium content — register to unlock

Journal & Source

Register to unlock

Metadata & Integrity

Premium content — register to unlock

Metadata & Integrity

Register to unlock